Royale Far Infrared Sauna Operational Guide

NOTE: Before powering on the sauna for the first time, please check and confirm the connection of all wiring (CONTROL BOX, HEATERS, TEMPERATURE SENSOR etc.) are correct and undamaged.

Power On /Off: Press to control the main power of the sauna unit.

Light: Press to control the lighting function

Time Display: Display the heating time of the sauna in minute(s)

Time: Press to adjust the setting of the timer.

Temperature Display: Display the actual interior temperature of the sauna room in 0C/0F.

Temperature: Press to adjust the temperature setting

• MAIN POWER: Plug in the main power to your household power.
• SAUNA POWER: To power on the sauna, press POWER ON/OFF one time on the inside control panel, POWER light should then light up, The TIME DISPLAY will flash 60. TEMPERATURE DISPLAY will flash 60. If you press POWER ON/OFF again, power is off, while everything goes out.
• HEATING TIME: When power is on, press TIME “+” or “-” to increase or decrease the emitting time of sauna room. When you press one time, it increases or decreases 1 minute. If you press the set-up button continuously for more than 2 seconds, the digital will change quickly. If you don’t press the button in more than 5 seconds, the digital will stop flashing, set-up value will be memorized. This value will be shown when you restart next time. During sauna session, set-up time will count down the minutes one by one.
• Set up the heating temperature: When you turn the power on, press TEMPERATURE button “+” or “-” to increase or decrease the heating temperature of sauna room. The temperature will increase or decrease I minute when you press one time. If you press the set-up button continuously for more than 2 seconds, the digital will change quickly. This value will be the set-up sauna temperature. If you don’t press the button in more than 5 seconds, the digital will stop flashing, set-up value will be memorized. It will show this value when you restart the next time.

When powering the sauna on, press WORK START/STOP button one time, WORK and HEAT light is on, the emitters will start emitting. (If you press this button again, emitters are off, WORK and HEAT light is off.) In the summer (room temperature is around 300C/860F), (such as 2 person sauna) heating time and actual inside temperature like the following datasheet:

actual inside temperature (degree Celcius)	40	50	55	60	66
Heating time (minutes)	5~7	17~19	23~25	31~33	43~45

When environmental temperature is low, heating requires additional time. The above data is only for your reference. When the temperature is at the set-up value, the digital control will maintain the set temperature. The WORK light will remain on and the HEAT light will turn off. When the top heating, the sauna will maintain the set-up temperature for some time, when the inside temperature drops 20C, the digital control will make the emitters continue heating until it reaches the set-up value. With the digital control, the inside sauna temperature is always around the set-up value.

• Inside reading lamp switch Press the light ON/OFF button one time to switch on, press again to switch off.